Endre søk
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • apa.csl
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Superheated steam drying of sawdust in continuous feed spouted beds: a design perspective
Karlstads universitet, Fakulteten för hälsa, natur- och teknikvetenskap (from 2013).ORCID-id: 0000-0002-9707-8896
Karlstads universitet, Fakulteten för teknik- och naturvetenskap, Avdelningen för energi-, miljö- och byggteknik. (Miljö- och energisystem)ORCID-id: 0000-0002-5764-7062
2014 (engelsk)Inngår i: Biomass and Bioenergy, ISSN 0961-9534, E-ISSN 1873-2909, Vol. 71, nr 0, s. 228-234Artikkel i tidsskrift (Fagfellevurdert) Published
Abstract [en]

Spouted bed drying technology shows promising results for the drying of unscreened sawdust in superheated steam. In this paper, the experiences from designing, running and evaluating two spouted bed continuous feed dryers are presented. Stable running conditions and drying results have been achieved. This has been particularly important for sawdust that will be compressed into pellets or briquettes. The spouted bed superheated steam dryer also shows high potential for energy efficient integration into sawmills. Our recommendation is thus, to use the outlet steam temperature as the control parameter for the outlet moisture content. A drying rate above and one below the fibre saturation level, can be identified. Visual observations through the viewing glass in the drying zone in both the dryers clearly showed that not all of the material participated in the spout at all times; there were, however, no indications of dead zones. A heat transfer analysis indicated that only about 70% of the surface area of the material was in thermal contact with the steam. This paper sums up the experiences regarding drying properties, control and system properties obtained when sawdust is dried using superheated steam as the drying medium. Further work on standardised dryers in series or in parallel is necessary to increase the capacity in the spouted bed dryer.

sted, utgiver, år, opplag, sider
2014. Vol. 71, nr 0, s. 228-234
Emneord [en]
Sawdust, Drying, Spouted bed, Sawmills, Superheated steam
HSV kategori
Forskningsprogram
Miljö- och energisystem
Identifikatorer
URN: urn:nbn:se:kau:diva-34915DOI: 10.1016/j.biombioe.2014.10.004ISI: 000345349500022OAI: oai:DiVA.org:kau-34915DiVA, id: diva2:780896
Tilgjengelig fra: 2015-01-15 Laget: 2015-01-15 Sist oppdatert: 2017-12-05bibliografisk kontrollert

Open Access i DiVA

Fulltekst mangler i DiVA

Andre lenker

Forlagets fullteksthttp://www.sciencedirect.com/science/article/pii/S0961953414004565

Person

Berghel, JonasRenström, Roger

Søk i DiVA

Av forfatter/redaktør
Berghel, JonasRenström, Roger
Av organisasjonen
I samme tidsskrift
Biomass and Bioenergy

Søk utenfor DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetric

doi
urn-nbn
Totalt: 745 treff
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • apa.csl
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf