Endre søk
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • harvard1
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
Experiments to Find Online Measurements of the Structure of the Tissue Paper Surface
Karlstads universitet, Fakulteten för teknik- och naturvetenskap, Avdelningen för kemiteknik.
Karlstads universitet, Fakulteten för teknik- och naturvetenskap, Avdelningen för kemiteknik.
(engelsk)Manuskript (Annet (populærvitenskap, debatt, mm))
HSV kategori
Forskningsprogram
Kemiteknik
Identifikatorer
URN: urn:nbn:se:kau:diva-3815OAI: oai:DiVA.org:kau-3815DiVA, id: diva2:208689
Tilgjengelig fra: 2009-03-19 Laget: 2009-03-19 Sist oppdatert: 2011-10-18bibliografisk kontrollert
Inngår i avhandling
1. Improvement of the tissue manufacturing process
Åpne denne publikasjonen i ny fane eller vindu >>Improvement of the tissue manufacturing process
2009 (engelsk)Licentiatavhandling, med artikler (Annet vitenskapelig)
Abstract [en]

The creping process and the conditions on the Yankee cylinder are the key factors in the production process. They need to be kept under good control in order to maintain a high and uniform quality. A natural coating always develops on the surface of the Yankee cylinder due to evaporation from dissolved and dispersed substances and to fiber fragments that remain on the surface after creping. Nevertheless, coating chemicals are sprayed onto the Yankee surface in order to modify the adhesion between the paper and the dryer cylinder. To be able to control the process, on-line measurements of coating thickness as well as of the crepe structure of the tissue paper produced would be very valuable. In the work described in this thesis, the coating layer was analyzed chemically and morphologically to provide information about the coating layer before starting any on-line measurements. The chemicals added and the constituents of the pulps are known to the paper producers, but what is left on the cylinder and whether there are different layers of coating still remain to be investigated. The chemical analysis indicated that the adhesive content was higher in an inner layer of the coating than in the outer layer. The relative amount of polyamide-amine resin calculated on the basis of the nominal nitrogen content in the resin was low indicating that the coating consisted of a significant amount of carbohydrates or other substances. The coating layer could not be considered transparent. It was observed that the coating was thick and appeared patch-wise and that it contained fiber fragments. Measurements on a laboratory scale, to further be applied on-line on the tissue machine, have been investigated and evaluated in this study. The thickness of the coating layer on a laboratory dryer has been measured. The method was based on fluorescence with an optical brightener added to the coating chemicals sprayed on the Yankee dryer. With a UV-LED (Ultra Violet - Light Emitting Diode) the coating layer was exposed to UV-light and the intensity of the light emitted by the optical brightener in the layer was measured. The intensity in the trials with different thickness of the coating and no coating was scattered and no trend could be seen between the different trial points. Attempts were made to measure the wavelength of the tissue paper produced with an optical fiber perpendicular to and at an angle to the paper surface. The paper was travelling in a slow speed while the measurements were made. The collected signal to noise ratio was low and it was not possible to detect any representative characteristic wavelength of the tissue.

sted, utgiver, år, opplag, sider
Karlstad: Karlstad University, 2009. s. 35
Serie
Karlstad University Studies, ISSN 1403-8099 ; 2009:13
HSV kategori
Forskningsprogram
Kemiteknik
Identifikatorer
urn:nbn:se:kau:diva-3646 (URN)978-91-7063-236-5 (ISBN)
Presentation
2009-03-27, Ericssonsalen 9C 204, Karlstad universitet, Karlstad, 10:00 (svensk)
Opponent
Tilgjengelig fra: 2009-03-19 Laget: 2009-02-19 Sist oppdatert: 2011-10-18bibliografisk kontrollert

Open Access i DiVA

Fulltekst mangler i DiVA

Personposter BETA

Boudreau, JonnaBeghello, Luciano

Søk i DiVA

Av forfatter/redaktør
Boudreau, JonnaBeghello, Luciano
Av organisasjonen

Søk utenfor DiVA

GoogleGoogle Scholar

urn-nbn

Altmetric

urn-nbn
Totalt: 131 treff
RefereraExporteraLink to record
Permanent link

Direct link
Referera
Referensformat
  • apa
  • harvard1
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annet format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annet språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf